Lado Exhaust Check Valve
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a check valve for the Lado Exhaust for Core One
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 1
- Wyświetlenia
- 267
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The Lado Check Valve is a simple check valve that allows airflow in only one direction in combination with the Lado Exhaust Duct (e.g. when venting outside).
It uses basic flaps that are held shut by gravity and can be pushed open with low air pressure.
The flaps open even with low fan speeds of 5% and can hence be used without any modification to the chamber exhaust fan speeds.
I recommend printing in PETG due to improved temperature resistance when exhausting hotter air during ABS/ASA prints.
As the attachment parts where the magnets are inserted is still 100% compatible with the original Lado Duct, it uses the same 8x3mm magnets.
The Valve Side and Printer Side are connected using M3 screws and nuts, though heat insets will work as well. The hole diameter is 4mm for standard M3 insets. I used M3x12 screws, but slightly shorter ones will work as well.
The check valve is compatible with both my window mount and blind cap remixes.