Bambu Lab A1 Hotend for KP3S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Complete printhead for the Kingroon KP3S using the hotend from Bambulab A1 series
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 387
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is also a remix of this fan holder https://www.thingiverse.com/thing:6294557, which I think was also a remix from other model, and this fanduct https://www.printables.com/model/327262-kingroon-kp3s-fan-duct
I adjusted the bracket so the hotend is at the same height of the volcano hotend I used to have on the kp3s. Added back the tabs with the holes for the screws that hold in place the original cover, so any shroud or fan holder already availabe should* fit. also modified it so it uses embeded nuts for the shroud and heat inserts for the hotend. the sleeve is now shorter as well.
I designed a new bracket to change the X endstop position, it can be held in place with the 2 original screws from the z endstop.
The fan holder now has slots instead of holes so the position of the fanduct can be adjusted left or right, also the height can be sligtly adjusted so you can set the fanduct right where you need it.
Also adjusted the angle of the outled of the fanducts to throw air directly at the tip of the nozzle.
Thats it. have fun.