BTT EBB2240-2209 Cable Cover - fan 25mm x 10mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Voron upgrade parts to reduce overheating of the EBB2240-2209 using a 25x10mm fan (Bambulab fan)
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
Hello everyone,
I had some spare 25x10mm 4-pin fans from Bambulab, and I thought it was a shame to throw them away since they were still functional. With a bit of soldering and some reverse engineering, I managed to mount them on the EBB2209. I’ve included both V1.1 and V1.2 versions in the downloadable files, depending on your main body extruder. Both versions are based on the official BTT repository.
I noticed that 25mm fan mounts already exist, but most of them are designed for internal use. The standard size for this type of fan is 25x7mm, so the Bambulab 25x10mm fans wouldn't fit. I addressed this problem with my modification.
Printing
- Use ASA or ABS, since the part will be in contact with heat. Use a usual profile for PIF (or whatever you think is relevant for this type of print).Use ASA or ABS, since the part will be in contact with heat. Use a usual profile for PIF (or whatever you think is relevant for this type of print).
- No support is needed if your overhangs and bridges print well. If you’re aiming for perfection like me, you can add a small amount of tree support to help with the largest bridge.
Config Problem
Intro
Here’s my current Klipper configuration for this fan (probably incorrect, by the way). The fan is always on, but at least it’s doing its cooling job. I’ll look into this more thoroughly this week (RTFM to myself). If you have a solution, or once I find one, I’ll update this post.
Bambu 25x10mm Fan Wiring:
- Dark wire → +5V
- Dark grey wire → GND
- Light grey wire → TACH
- White wire → PWM
Klipper Current Config:
[temperature_fan ebb_cooling_fan]
pin: EBBCan:PB14
tachometer_pin: EBBCan:PB15
tachometer_ppr: 2
max_power: 1.0
shutdown_speed: 0.0
kick_start_time: 0.5sensor_type: temperature_mcu
sensor_mcu: EBBCan
min_temp: 10
max_temp: 80
target_temp: 50
control: watermark