Snowmote 2 - Case for Pubmote
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d printed case for the Pubmote project, a VESC onewheel tilt remote
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 104
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
3d printed case for the Pubmote project, a VESC onewheel tilt remote.
Hardware Requirements
Battery
1500mAh Lipo battery (this is the one the case is designed for, but others of similar dimensions or smaller will work)
2 x M3x5 screws
4 x 1.27mm header pins
1 x Pull-up resistor (10k Ohm will do)
Printing Instructions
Print in your preferred material with as much infill as you like, but here are some print settings recommendations:
30%-50% infill, so the large, flat areas are sturdy
Face down on the bed, so no supports are needed
TPU lid and port cover pieces (The lid must be TPU if you want to be able to get the display into it!)
PETG or other solid floor piece