1 / 1
Anti skew Enxlosure lid clamps — zdjęcie 1

Anti skew Enxlosure lid clamps

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple part to correct skew in my EnXLosure lid which prevented it from fitting to the XL frame properly.

Ocena
4,875 / 5
Polubienia
16
Pobrania
137
Wydruki
7
Wyświetlenia
461
Oceny
8

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial
Overview

My assembled EnXLosure lid skewed outwards more than the magnets could pull inwards. I designed this simple part to hold the lid at the correct width. The lid can still be lifted straight off to be removed.

Print Settings

I used PETG with the same settings as the EnXLosure parts: 3 perimeters with 25% infill. The part is already correctly oriented and no support is needed. Two copies are the minimum but you may use more if required.

Hardware

Per holder:

2 x M4 x 8mm bolts

2x M4 30 series T nuts

This is the same spec as the Aliexpress EnXLosure hardware kit.

Installation

Attach to the upper frame at the front of each side. The EnXLosure lid will then drop down from above like before but be held at the correct width.

Remixing

Since this is based on a paid model I can't include my Onshape source link, but a STEP file is included to edit. This is a chunky part. I imagine some might like to remix it into a nozzle/tool holder or perhaps make it narrower from side on and print it on its side.

Tagi