Anti skew Enxlosure lid clamps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple part to correct skew in my EnXLosure lid which prevented it from fitting to the XL frame properly.
- Rating
- 4.875 / 5
- Likes
- 16
- Downloads
- 139
- Makes
- 7
- Views
- 463
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Overview
My assembled EnXLosure lid skewed outwards more than the magnets could pull inwards. I designed this simple part to hold the lid at the correct width. The lid can still be lifted straight off to be removed.
Print Settings
I used PETG with the same settings as the EnXLosure parts: 3 perimeters with 25% infill. The part is already correctly oriented and no support is needed. Two copies are the minimum but you may use more if required.
Hardware
Per holder:
2 x M4 x 8mm bolts
2x M4 30 series T nuts
This is the same spec as the Aliexpress EnXLosure hardware kit.
Installation
Attach to the upper frame at the front of each side. The EnXLosure lid will then drop down from above like before but be held at the correct width.
Remixing
Since this is based on a paid model I can't include my Onshape source link, but a STEP file is included to edit. This is a chunky part. I imagine some might like to remix it into a nozzle/tool holder or perhaps make it narrower from side on and print it on its side.