1 / 3
Microphone Boom Arm Mount To Monitor Arm
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom adapter to fit generic microphone arm mount to any pole monitor mount. 2-part design so the mic can rotate freely
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 377
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (1)Kolekcje (10)Powiązane
A quick adapter to mount your generic Microphone stand like this one, to fit any 35mm Pole shaped monitor stand. Features sturdy cable clip for tidy setup!
Hardwares required:
- Any pole based monitor arm/mount system with diameter of 35 mm
- Basic microphone stand, with detachable C-clamp. The insides should be around 12 mm
- M4x20mm Bolt, and M4 hex nut
Install instructions:
- Remove the C Clamp from the microphone mount
- Insert the locking clamp to the Monitor Pole, adjust the height accordingly
- Chuck your mic stand to the printed part
- slide the Adapter into the monitor pole
Notes:
- The adapter is designed to fit loosely on the monitor pole, so it can be moved freely
- The adapter is designed to fit tight on the microphone stand.
- Printed using PA-CF at 20% Infill. 4 shells, 4 solid fills. Should work with other filament as well
- Recommended print settings:
- 20% infill for the Mount adapter
- 50% infill for the locking clamp
- No Supports required!
Posted on 14 September 2025