Fixed bracket for flexible phone arm with gripper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is fixed bracket to hold a generic flexible phone arm with a gripper. The arm has a diameter of 9,9mm.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is fixed bracket to hold a generic flexible phone arm with a gripper. These arms usually come with a suction cup to mount them on a windshield in a car. The arm itself is a thick wire with a plastic coating that can be bend in the position you want the phone to be. By arm broke out of the suction cup and got unusable. I then designed this bracket to fit the arm so I can mount it at my desk and hold a phone for video calls.
The bracket fits arms with diameter of 9,9mm and achieves a light press fit. Additionally zip ties (max. 5mm wide and 0,5mm thick) can be used to hold the arm in place. The bracket as as 90° hole at the end to support the torque from the phone holder, see images for details. The whole bracket gets screwed down with up to 4 screws through the center.
Assembly:
- Bend the end of your arm sharply to 90°
- Insert arm in to bracket.
- If press fit is not enough use zip ties.
- Screw down bracket in desired place.
Print instructions:
- No supports needed
- Recommended layer height 0,2 mm
I would be happy to see some of your makes posted :)
Source files in the Alibre Atom format is available but the website does not allow the upload. If you need it send me a message.