1 / 3
NEMA17 heatsink clip with 4040 fan — zdjęcie 1
1 / 3

NEMA17 heatsink clip with 4040 fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I found that my extruder stepper was running hot (even after tuning the current) on 15-30hr prints and I was getting…

Ocena
5 / 5
Polubienia
7
Pobrania
60
Wydruki
1
Wyświetlenia
515
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I found that my extruder stepper was running hot (even after tuning the current) on 15-30hr prints and I was getting print failures due to the printed drive gear on the Pitan extruder softening and spinning on the D shaft.

I found ScottW1's design to be elegant and sufficiently low-profile to clear the gantry shoulder, but I wanted to add a 4040 fan.

This design assumes that you will be using a thermal pad between the heatsink and stepper and may not work correctly without one as it does not provide much clamping pressure on the heatsink.

The heatsink this is designed for is 40x40x11

Edit: I added a version that holds the heatsink a little bit tighter to the stepper.

Print Settings

Printer:

Frankenprinter

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

20-30%

Filament:

whatever PETG or ABS


Notes:

Print it circle side down. I have not had any issues with the legs breaking due to the layer orientation.

How I Designed This

I extracted the basic dimensions of the clip from ScottW1's design and re-drafted it in Fusion360 and added holes for the 4040 fan.

Category: 3D Printer Parts

Tagi