SKÅDIS mount for Rigol DS1054Z
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your oscilloscope to an IKEA Skadis board.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 252
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
On the back of my electronics workbench I have a couple of IKEA Skadis board to mount my tools to.
These are the brackets I used to mount my Rigol DS1054Z oscilloscope.
Note that these brackets are actually a mirror of each other. It is designed to be used with an right angle power cord (hence the cut out in the bracket). To slide it in, first click “out” the front feet and put them through the whole. The “fixed” front feet should latch behind the front of the bracket. Once it is in place, you can put up the front feet that you “clicked” out before (I added a picture from the bottom that hopefully adds some clarity).
It is based around the T-Clip System by @LineArcLine and I used the T-Clip negative hole by capze to create this model. You will need to print 4 of the T-Clips that match your Skadis board in order for this mount to be attached to the Skadis board.