1 / 3
cutter for k1 for the possibility of installing MMU — zdjęcie 1
1 / 3

cutter for k1 for the possibility of installing MMU

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

knife for k1 for the possibility of installing MMU. cutter based on KKm and mellow magneto cutter

Ocena
0 / 5
Polubienia
13
Pobrania
43
Wydruki
0
Wyświetlenia
473
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

knife for k1 for the possibility of installing MMU. cutter based on KKm and mellow magneto cutter.

why did I decide to create my own cutter based on kkm? - It's simple, I didn't like the existing extruders with cutters that didn't have an adjustable clamp (with the exception of the orbiter b2-based cutter). I also didn't want to leave the stock extruder so that most of the audience could install the knife. I also adapted the mellow cutter for printing.

BOM:
All the gears and bearings from the stock extruder

  • 1x ECAS04 fitting
  • 2x M3 washers (1mm thick, only for stock K1 motor)
  • 4x MR84ZZ bearings
  • 6mm long piece of M2 screw (without head)
  • 2x 4x15mm pins
  • 1x tension spring
  • 1x M3x10 or longer SHCS screw
  • 3x M3x18 SHCS screws
  • 1x M3x20 FHCS screw
  • 7x M3 heat inserts (4.6mm-5mm outer diameter, up to 5mm length)
  • 2x M3x8 XMSJ (Flat head, not countersunk) (or x4, if you will use printable version of cutter)

 

 

 

Tagi