2U Rack-Mounted HomeAssistant System - 19in

I needed to clean up my networking rack after porting my Adguard service from my HomeAssistant instance to 2 RPi 4s, and decided to add some nice-to-haves to the rack.

Overview

Beelink Mount

• Fits Beelink SEI-series mini PCs

• 3 keystone ports for 1x ethernet and 2x USB passthroughs

RPi 4 Mount + 3010 fan mount and Rack Shroud

• Fits 2x RPi 4s

• 3010 fan mount

  • This also acts as a support bracket for the 2 RPis

• RPi Mount slides into the Rack shroud and clicks into place

Philips Hue Bridge Mount

• Bridge slides into place using its screw hole mounts

Hardware Required

• 6x M4 heat set inserts

• 6x M4x8 bolts

• screws to mount this to your networking rack

Install

It's a bit of a pain to screw the parts together. 

• I suggest putting a screw in the furtherest hole (closest to the front of the rack) , holding it still with a finger, then turning the opposite piece (with the heatset insert) so that it screws into place that way. 

• The 2 closer screws you can use an allen key to tighten

Both RPis slide into their mount

Note: The RPi bracket acts as a structural piece for the rack, so even if you aren't installing RPis, still print the bracket and slide it into the rack 

Thanks a ton to the original 2 designers of the Beelink mount and Hue bridge mount, and for including STEP files! They helped a lot in serving as the basis for this model.

Happy printing!

Like what I do and want to support me? Buy me a coffee!