1 / 4
Grease Gun Snap-Fit Tube Cap — zdjęcie 1
1 / 4

Grease Gun Snap-Fit Tube Cap

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This printed cap is designed to snap over the top of standard grease tubes for grease guns.

Ocena
5 / 5
Polubienia
6
Pobrania
37
Wydruki
2
Wyświetlenia
133
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Open Community License v1

This printed cap is designed to snap over the top of standard grease tubes for grease guns. If you have a grease gun, chances are you have some of these gross, unfinished tubes of grease wrapped in plastic and rubber bands to stop them from spilling. Well now, there's a better way to solve this issue with the help of your 3D printer :)

Printing Instructions: Finding the Best Fit

The fit of the cap is highly dependent on the tube and tolerances of the print. Machine tolerances, material warping, water absorprtion, or even nozzle size and slicing profile can change how the cap fits on and stays on.

If the part is a little too loose, too hard to put on, or rattles too much when snapped on, you should try to scale the part in your slicer a little bit:

  1. Won't snap on: try scaling by +1% in X and Y

  2. Too loose/does not snap positively: scale by -1% in X and Y

  3. Rattles too much after snapping it on: scale Z by -1%

It might take a few iterations to get the perfect print. I printed this part in Bambu Lab clear Polycarbonate using a 0.6mm nozzle in a heated chamber at 65C (cooled slowly after finishing to reduce warp). I chose polycarbonate mostly for its dimensional stability after absorbing water from the air, chemical inertness, and its impact resistance. If I dropped my tube on its cap, for example, I didn't want it to fracture and spill grease everywhere.

Design Intent

I designed this for use with Lucas Red and Tacky grease. Tubes are standardized, but might vary slightly between manufacturers and products. I included the native CAD file (solidworks) as well as a step file if you need to try modifying it. If you do this, please share your work with everyone else who might also find it useful! Generally, my design process was to first model the tube, then use small offset profiles to design an annular snap fit feature for the metal end ring on the cardboard tube,

If your cap eventually loosens up, breaks, or otherwise stops working with just a snap, I designed the cap to feature castellations. This way, you can still secure it onto the tube with rubber bands, a velcro strap, or even a piece of string as a backup. If your cap ever does stop working, I wanted to make sure there's another way to secure it until it's possible to print a new one.

Tagi