1 / 4
Stackable FIFO can storage
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Yet another FIFO can storage, but this one is stackable and made out of hexagons.
- Ocena
- 4,846 / 5
- Polubienia
- 721
- Pobrania
- 1540
- Wydruki
- 14
- Wyświetlenia
- 9458
- Oceny
- 13
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 14) (Komentarze: 25)Remiksy (2)Kolekcje (1024)Powiązane
Stackable FIFO can storage. Designed to hold 8 cans ~75 x 115 mm (3" x 4.5"). Two, probably three, can be stacked on top of each other.
Printing
- No supports.
- I've printed 3 perimeters, 15% infill.
- Print each one of the walls on the back, flat side.
- Print 4 x connector on the flat side.
- Print 4 connecting bar, bar facing down.
Assembly
- Front and back walls have tabs and holes to get them aligned. Use connectors to connect front and back parts together.
- Connectors are designed with fit tightly and hold by friction. Either use mallet or glue if you have problems fitting them together.
- Connecting bars work the same way as connectors. They are connecting left and right side of the box.
- Please check the photo where connection points are recommended.
- Connectors can be used to connect stacked containers if needed.
STEP files attached. Enjoy!