1 / 3
Dog Fridge Magnet Shepherd - 12mm x 3mm — zdjęcie 1
1 / 3

Dog Fridge Magnet Shepherd - 12mm x 3mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D dog magnet for your fridge.

Ocena
0 / 5
Polubienia
3
Pobrania
11
Wydruki
0
Wyświetlenia
57
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

Enter a 3D dog magnet for your fridge. I wanted a dog magnet that was truly a dog. Not just a flat or semi flat magnet.

I found a scanned model of a Shepherd which was perfect for this. Uses a 12mm x 3mm magnet. Plenty strong enough.

  1. Make sure to orient it with the flattest side on the build plate
  2. Make sure to add a pause to insert the magnet

Enjoy!

My Print Settings:

  • Material: PLA
  • First layer height: 0.3mm
  • Layer height: 0.2mm
  • Wall thickness: 0.45mm 
  • Wall loops: 2
  • Wall order: Outer/Inner
  • Wall generator: Arachne
  • Bottom surface pattern: Rectilinear or Monotonic
  • Top surface pattern: Doesn't matter as there is very little “top surface”
  • Bottom shell thickness: 0.7mm
  • Top shell thickness: 0.8mm
  • Infill density: 15%
  • Infill pattern: Adaptive Cubic
  • Nozzle size: 0.4mm 
  • Supports: Yes you can, but not required 
    • If you do use them make sure to use threshold angle of 15% and “on build plate only
  • Speed: You decide based on your printer! I used 60mm for walls and 100mm for infills

Total print time 1hr 45min

Dog in picture is Prusament PLA Gentleman's Grey

Tagi