1 / 3
Dog Fridge Magnet Shepherd - 12mm x 3mm
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D dog magnet for your fridge.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 11
- Makes
- 0
- Views
- 57
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
Enter a 3D dog magnet for your fridge. I wanted a dog magnet that was truly a dog. Not just a flat or semi flat magnet.
I found a scanned model of a Shepherd which was perfect for this. Uses a 12mm x 3mm magnet. Plenty strong enough.
- Make sure to orient it with the flattest side on the build plate
- Make sure to add a pause to insert the magnet
Enjoy!
My Print Settings:
- Material: PLA
- First layer height: 0.3mm
- Layer height: 0.2mm
- Wall thickness: 0.45mm
- Wall loops: 2
- Wall order: Outer/Inner
- Wall generator: Arachne
- Bottom surface pattern: Rectilinear or Monotonic
- Top surface pattern: Doesn't matter as there is very little “top surface”
- Bottom shell thickness: 0.7mm
- Top shell thickness: 0.8mm
- Infill density: 15%
- Infill pattern: Adaptive Cubic
- Nozzle size: 0.4mm
- Supports: Yes you can, but not required
- If you do use them make sure to use threshold angle of 15% and “on build plate only
- Speed: You decide based on your printer! I used 60mm for walls and 100mm for infills
Total print time 1hr 45min
Dog in picture is Prusament PLA Gentleman's Grey