Phoneholder - for desk and simrig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adjustable phone holder which can either be used on a desk at two different heights, or can be mounted on a simrig
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 1
- Wyświetlenia
- 204
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
An adjustable phone holder in 3 variants. Here the specs to all version:
Small: 100 mm high
High: 130mm high
Both, the large and the small, have 4 100mm wide and 1mm deep indents for rubber feet to keep them from sliding. The phone holder is 15mm wide, which is a little wider than the Mous case on my current phone. Cutout for the charging cable is 15x20 mm, more spacious then most cases on the market. The cable can be routet through the stand with the cutout in the back, which was also used to make the base of the stand a little more interesting.
The sim-version uses M8 hardware, which is what my rig is based on. However, step files will be included to adapt any and all of what is included to the sizes you need.
Print parameters:
3 perimeters
15% infill