Wemos D1 Mini (ESP8266) Case met USB-C en 4-pins JST-connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wemos D1 Mini (ESP8266) Case met USB-C en 4-pins JST-connector – voor GPS UDP Tracker
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 256
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Wemos D1 Mini (ESP8266) Case met USB-C en 4-pins JST-connector
This case is specifically designed for a Wemos D1 Mini (ESP8266) with a USB-C connector and a 4-pin JST-XH connector.
The enclosure is part of the GPS UDP Tracker project.
The related firmware and documentation can be found on GitHub:
The case provides a clean, sturdy, and well-fitting protection for the Wemos D1 Mini, with openings for the JST connector and easy access to the USB-C port.
Features
- Designed for Wemos D1 Mini (ESP8266) with USB-C port
- Extra cutout for JST-XH 4-pin connector
- Assembled with 4× ISO 7380-1 Stainless Steel A2 M3×8 mm screws
- Compact, easy-to-print design — no supports required
- Fits neatly into the GPS UDP Tracker project
Required Parts
| Part | Quantity | Note |
|---|---|---|
| Wemos D1 Mini (ESP8266) USB-C | 1 | Main board |
| JST-XH 4-pin connector | 1 | For power/IO |
| ISO 7380-1 Stainless Steel A2 M3×8 mm screws | 4 | For assembly |
| 3D printing material (ASA/PETG) | – | See recommendations |
Assembly Advice
Place a small piece of Kapton tape (or other heat- and insulation-resistant tape) over the antenna area of the Wemos D1 Mini, on the side where the JST connector pins are located.
The distance between the antenna trace and the JST pins is quite small, which could lead to a short circuit during assembly.
Adding a small piece of Kapton tape prevents this risk while maintaining good antenna performance.
Pro Tip
In the opening aligned with the LED on the Wemos D1 Mini, insert a short piece of clear filament.
Then carefully melt it flat from the inside using the tip of a warm soldering iron.
This way:
- the lid remains fully closed, and
- the status LED stays clearly visible through the filament.
A simple yet elegant touch for a professional finish.
Recommended Print Settings
- Material: PLA or PETG
- Layer height: 0.2 mm
- Infill: 20–30%
- Supports: Not required
- Orientation: Bottom down
- Optional: Brim for better adhesion
Design Info
- Model tolerances fit standard Wemos D1 Mini dimensions
- JST opening supports XH-series 4-pin connectors
- Lid secured with 4 × M3 screws
- Provided in STL
