Vibratory base for 38x38 mould

NOTE print at 101% or higher if your printer cant print tight tollerances. For me its a super snug fit, if you have “perfect” non bulbous corners

General purpose vibratory base for anything thats 38x38. I use it for moulds for high temp o-rings, gaskets etc. 

Made specifically for the:

Made by: Studmuffin

I was looking for a replacement silicon sock for my Creality Spider V2 hotend (which is the same as the V3). Countless of Reddit posts later i found the mould he made, and tutorials online that making your own isn't that bad. 

I printed Studmuffins' model out, which fit perfectly. But felt like I wanted a vibrating base to get out all potential air bubbles. So i modeled myself a base frome some cheap parts i had laying around. Primarily, phone vibrators that are 10mm x 3mm(-ish). And a 10-12mm toggle switch  all hooked up to either a 9V battery with a step down converter or any plain old usb 5V cable. And two M3 heat set inserts. 

Supports not needed (if you print with a fan on) otherwise I recommend tree supports. 

If you are making your own moulds. This should be compatable as long as your base fits a 38x38 square base shape. And the top bolts are 31mm spaced apart from each other (center of holes).