BMW Cable Holder 33181181218
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a BMW Cable Holder 33181181218 that can be printed flat on a 3D printer. A 0.2 nozzle is recommended.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 106
- Wydruki
- 0
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
This cable holder replaces the BMW OEM clip 33 18 1 181 218 (33181181218). It routes and secures wiring on the suspension—typically the brake pad wear sensor at the rear, and in some models also ABS/signal wires—so cables don’t chafe or hang loose. The original part is often pricey or hard to find; this print is a precise, robust alternative. Compatible with many 1990s/2000s BMW platforms (e.g., E36, E39, E46, E53 X5—please compare to your original part and location).
Print settings
- Material: PETG (tough, better heat/UV resistance than PLA).
- Nozzle: 0.2 mm — the model is tuned for this.
- Layer height: 0.16–0.24 mm.
- Perimeters: 7-8 walls for durable snap features.
- Infill: 100 %
- Orientation: Flat, with the clip base on the bed; latch facing up for crisp edges.
- Supports: Generally not required; at most a tiny support under the latch if your printer needs it.
Post-processing & installation
- Lightly deburr edges (craft knife/file).
- Optional: gentle heat-set (hot air ~80–90 °C) for extra toughness—don’t overdo it.
- Press the cable into the clip; the holder snaps into the factory opening. Firm fit without pinching the wire.
Dimensions & fit
- Geometry follows the OEM part; tolerances chosen for a positive snap and secure cable retention.
- If a slight first-layer “elephant’s foot” interferes, clean the groove quickly for a perfect fit.
Use/compatibility
Common on: BMW E36, E39, E46, E53 X5 and others. Typical position: rear suspension for the pad wear sensor. Always visually verify against your old part.