1 / 10
Sunshine's ITX NAS CASE 6 SSD SFX 140mm FAN MESH — zdjęcie 1
1 / 10

Sunshine's ITX NAS CASE 6 SSD SFX 140mm FAN MESH

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

So it is a fully working computer case for ITX board.

Ocena
0 / 5
Polubienia
19
Pobrania
32
Wydruki
0
Wyświetlenia
540
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Hi

So it is a fully working computer case for ITX board.
I'm in 100% author of this project, and i do not agree to edit it or publish it somewhere else without my aproval.
I spend on it like 2 weeks of free time, and it was not that easy to design as someone might think.
 

What you need?

  1. M5 and M4 screws
  2. M5x14 - 5mm or 10mm, i do NOT recommend to go with longer. Because you can hit something on the motherboard. But for back panel you can go with any lenght.
  3. M4x16 - 5mm or 10mm longer could work too! (psst, you can even use m3 with just simple nut and washers ;d)
  4. For wind tunel use standard computer screws for fans


So about the features:

  • You can have up to 6 SSD with it
  • SFX PSU aaand SFX-L (but cable management will be harder ;D)
  • 140mm front FAN, 
  • ON/OFF switch cutout
  • fully modular design
  • print without any supports!
  • HEX design on front, MOBO trace, back panel
  • cutouts for cable management
  • maybe more in the future

For print settings:

  1. PETG for MOBO trace is a MUST and bare minimum
  2. nozzle 0.6mm
  3. Initial layer height 0.2mm
  4. layer height 0.2mm
  5. 220C on V4 chinesse hot-end for P1P :D, so for original one could be 240C?
  6. Ironing is nice for finish but sky rocked the print time (without 1D_22H and with 2D_11H :D :D :D)
  7. get your cooling right for your material
  8. speeeed, well it's kinda up to you. I'm going with transparent PET-G so 90mm/s and accel 6k. Also using a speed by height is a nice feature, cuz you can get your first 10mm really good and hard. So the print will be stronger without the need of using a lot of material!
  9. Infill gyroid 20% with 3000accel, don't go HIGHER with that, cuz your print peace will go flying trough the window with it :D
  10. use brim for PSU bracket, rest should be fine without it.


I'm sharing this project only for PERSONAL USE!
If you want to sell it, we need to talk about licensing this…

If you have found that project good, here is a page where you can buy me a coffee and vote on what i will do next: https://ko-fi.com/thesunshinedude


Or just drop a like on my artstation: 
https://www.artstation.com/lukasz_kiebala

Support and request:
[email protected]
https://discord.gg/6NKQtxDTGQ

Best regards, Sunshine

Tagi