Fitbit Versa 2 Charger Adapter for DIN Rail Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small adapter to hold a Fitbit Versa 2 charger to a DIN rail clip, or anything else with two M4 screws
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 418
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple clip on adapter for a Fitbit Versa 2 charger, with two 4mm holes on 45mm centers. I recommend printing in PETG or nylon, since it's a very snug clip on fit. I used M4x8mm screws to ensure clearance under the radius while still being able to thread into this DIN rail clip (the white nylon printed part in photos), but you can probably get away with up to 12mm, or even longer if you're not threading directly against the back. Works fine with a single adapter to one side of the cable in the back, but I already had a prototype (on the right in photos) set up, so I just used both.
There are a few different charger designs for the Versa 2. Take a close look at my pictures before printing, but it's such a small print it only took me 5 minutes to print with a 0.8mm CHT nozzle, so it's not a huge investment of filament.