1 / 1
Enclosure for collecting unwound filament after a filament change. — zdjęcie 1

Enclosure for collecting unwound filament after a filament change.

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure enables filament changes without opening box, keeping filament safe from dust and humidity.

Ocena
0 / 5
Polubienia
4
Pobrania
14
Wydruki
0
Wyświetlenia
270
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

When using a filament box with a tube feed to the extruder, such as on the Prusa XL, a filament change leaves a long section of filament exposed, no longer protected from humidity and dust by the tube.

To keep the exposed filament dry and clean after a filament change, the filament and the first section of the PTFE tube are inserted into the opening of the housing. The (white) seal closes off the spiral chamber inside the housing, preventing humidity and dust from entering.

This ensures the filament stays protected without requiring you to open the filament box to roll up the loose filament, while the tubes are conveniently stored and ready for the next filament change.

To use enclosure on both sides of printer housing, mirror parts in your slicer.

Part list:
  • printed parts

    • enclosure | quantity: 1

    • cover | quantity: 1

    • sealing | quantity: 4

    • fixing ring | quantity: 1

  • countersunk screw ⌀3x8 (for wood) | quantity: 2

  • countersunk screw ⌀3x10 (for wood) | quantity: 3

Print instruction:
  • material: PETG + flexible filament

  • orientation: as stored

  • supports: partial required

  • layer height: 0,2mm ... 0,3mm

  • nozzle diameter: 0,4mm or 0,6mm

  • brim: not required

  • enclosure:

    • recommended for enclosure

    • not required for rest of the parts

Used Settings for ColorFabb varioShore TPU:

Parameter

Value

Extrusion Multiplier

0.65

Material Density

1.22 g/cm³

Idle Temperature

70 °C

Nozzle Temperature

First Layer: 250 °C

 

Other Layers: 250 °C

Bed Temperature

First Layer: 80 °C

 

Other Layers: 80 °C

Assembly instruction:
  1. remove supports and deburr parts if needed

  2. add sealing to housing

  3. add cover and fix cover with countersunk screws ⌀3x8

  4. assemble enclosure to housing of printer using fixing ring and countersunk screw ⌀3x10

  5. allign position of enclosure to ensure a smooth bending radius of PTFE tube

  6. tighten countersunk screw ⌀3x10

  7. insert unwound filament and PTFE tube through sealing

To visit complete XL enclosure, follow link below: 

Tagi