Enclosure for collecting unwound filament after a filament change.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enclosure enables filament changes without opening box, keeping filament safe from dust and humidity.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 14
- Makes
- 0
- Views
- 270
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
When using a filament box with a tube feed to the extruder, such as on the Prusa XL, a filament change leaves a long section of filament exposed, no longer protected from humidity and dust by the tube.
To keep the exposed filament dry and clean after a filament change, the filament and the first section of the PTFE tube are inserted into the opening of the housing. The (white) seal closes off the spiral chamber inside the housing, preventing humidity and dust from entering.
This ensures the filament stays protected without requiring you to open the filament box to roll up the loose filament, while the tubes are conveniently stored and ready for the next filament change.
To use enclosure on both sides of printer housing, mirror parts in your slicer.
Part list:
printed parts
enclosure | quantity: 1
cover | quantity: 1
sealing | quantity: 4
fixing ring | quantity: 1
countersunk screw ⌀3x8 (for wood) | quantity: 2
countersunk screw ⌀3x10 (for wood) | quantity: 3
Print instruction:
material: PETG + flexible filament
orientation: as stored
supports: partial required
layer height: 0,2mm ... 0,3mm
nozzle diameter: 0,4mm or 0,6mm
brim: not required
enclosure:
recommended for enclosure
not required for rest of the parts
Used Settings for ColorFabb varioShore TPU:
Parameter | Value |
|---|---|
Extrusion Multiplier | 0.65 |
Material Density | 1.22 g/cm³ |
Idle Temperature | 70 °C |
Nozzle Temperature | First Layer: 250 °C |
| Other Layers: 250 °C |
Bed Temperature | First Layer: 80 °C |
| Other Layers: 80 °C |
Assembly instruction:
remove supports and deburr parts if needed
add sealing to housing
add cover and fix cover with countersunk screws ⌀3x8
assemble enclosure to housing of printer using fixing ring and countersunk screw ⌀3x10
allign position of enclosure to ensure a smooth bending radius of PTFE tube
tighten countersunk screw ⌀3x10
insert unwound filament and PTFE tube through sealing
To visit complete XL enclosure, follow link below: