1 / 4
SSUPD Meshroom S PC case feets (15, 20, 25, 45, 50, 55 and 60mm height)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case feets
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- GNU General Public License v3.0
SSUPD Meshroom S feets in 15, 20, 25, 45, 50, 55 and 60mm. Should also work well with NCase M2 and M3.
Needed hardware (multiply by the number of feets)
- 1x M3x5x4 heatset
- 1x M3 bolt of 6, 8 or 10mm length
- (OPTIONAL) 1x M3 shim/washer, since the holes in case are meant for 6/32" imperial bolts (about 3.5mm), M3x6x1 shims works well. Alternatively using M3 bolt with wide head might work just as well.
- (OPTIONAL) 1x 10mm wide self adhesive silicone feet. There's 0.6mm deep 10.5mm wide recess in the feat meant for it. I used 10x2mm self adhesive silicone feets and it worked really well.
Notes
- The source CAD file is included and license is open source. Adjust it as you need.
- To get the heatset flush I usually get it almost all the way in, leaving maybe 1mm or so sticking out and then, while heatset is still hot, pressing it with something very flat. a hotend flat wrench will work or even a glass table. This makes the heatsets flush with surface and also makes heatset get in under right angle.
- Using hex bolts and ball ended bit or allen key significantly simplifies installation of them.