Chroma Print Head mount for Ender 5 Plus Mercury One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CoPrint Chroma Print head mount for a Ender 5 Plus that had the mercury one upgrade
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 20
- Wydruki
- 2
- Wyświetlenia
- 143
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Co-Print Chroma Print head mount for a Ender 5 Plus that had the mercury one upgrade
The front plate takes 5 - 3mm x 5 threaded inserts. 3 for the Chroma Head and two for the belt clamps. Included a back view diagram where to add the inserts.
The bottom and back plates were modified to exclude the trihorn duct and fan mounts (since the chroma head has a built in fan)
Back Plate takes 4 - 3mm X 5 threaded inserts
Top mount was modified
Belt clamps aren't modified but I included their file for your convenience. (You'll need two belt clamps.)
Assemble is similar to other print head mounts found on the Zero G website
4 - M3 x 35 screws to mount the front plate to the back plate (going through the top and bottom brackets)
3 - M3 x 20 screws for the print head.
I printed mine with ASA plastic, following Zero G's recommendations for print settings.
Recommended print settings (From Zero G's website)
- First layer height: 0.25mm (This is required. Our parts have been designed for this.)
- Layer height: 0.2mm
- Extrusion width: 0.4mm, forced
- Infill pecentage: 40%
- Infill type: Adaptive Cubic, grid, gyroid, honeycomb, triangle, or cubic
- Wall count: 4
- Solid top/bottom layers: 5
- Seam placement: REAR
- This is important as we have seam relieve features that line up with the seam placement.
- Supports: NONE
As always use with your own risk.