MaxPC10's Creality Dry Box 2.0 Parametric Legs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remake of MaxPC10's original Creality Filament Dry Box 2.0's legs, but in a set of 4, with small support pins.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
A remake of MaxPC10's original Creality Filament Dry Box 2.0's legs, but in a set of 4, with small support pins along the height of the legs.
Print with which every settings you want, I don't think there's any need to have more than 2 walls, but 3 would be safer. You should not need a brim, unless you have poor bed adhesion.
The support pin will need to be removed, but this can be done in a few seconds with sandpaper or a blade, however the blade may not leave as smooth a finish (see photos).
Notes on the photos:
- Please ignore the lines on the shorter legs, I ran out of filament and the change left the lines.
- A close up of the support pins.
- The top down view is of the 160mm legs, next to a segment of the original leg design. They fit in the stand identically.
- An example of the pins removed using 3 different devices (foot sander, sandpaper, BambuLabs bed scraper and supports before they've been removed)