ABB Jussi Cover for IKEA Rodret/Somrig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A friction fit cover designed to fit on-top of existing ABB Jussi light switches, adapting them to IKEA Rodret/Somrig.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 23
- Wydruki
- 2
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
A renter-friendly, non-invasive way of converting dumb light switches to smart switches using IKEA Rodret or Somrig – without ever having to take the old one apart, install a relay behind the switch or replace anything. Just click the cover on top of the old one and you're good to go!
Removing it is as simple as grabbing a hold of it and pulling straight out, if you have printed it too tight it might pull the underlying switch-plate with it, in that case simply push the switch-plate back in until you hear a click and it will be all restored.
Printing
- I have used dirt-cheap white PLA which worked fine, but for long-term use I would probably recommend PETG
- I printed with a 0.6mm nozzle on a Ender 3 v2 using default slicer settings, that worked fine and yielded a good-enough result. Any nozzle size ≤0.6mm should work fine too.
- I printed with a 0.2mm layer height but I am sure this too can be tweaked quite a bit
- Position the model so that the switch side faces up and use paint on supports on the inside, only the flat overhang was needed for me. Either way this will be covered and not seen by the end-user.
- If you want a extra nice top surface I recommend enabling ironing in your slicer, not by any means needed, but gives it a nice finish if you have it tuned in correctly.