Aqara T2 2-Channel Zigbee Relais DIN-Rail Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small bracket to mount the Aqara T2 to a DIN-Rail
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 251
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a bracket to mount my Aqara T2 2-Channel Relais module on the Trident, so I made one. Put 2 heatsets into the body, screw the clip to the mount and you are good to go. Contains a small piece of inbuilt support, you can just push it out with a screwdriver after printing and then route the antenna through there.
BOM:
2x M3x4 standard Voron heatset inserts
2x M3x8 SHCS or BHCS screws
Print with standard Voron settings and shrinkage compensation turned OFF. This will fit just snug when printed in ABS/ASA. For PLA or PETG you might have to reduce the model size by ~0.5% or just glue the relais into the mount.
---
Also contains a remixed version of the DIN Rail Bracket Redux by @herr_brain, licensed under BSD-2
https://www.printables.com/model/472505-din-rail-bracket-redux