Aqara T2 2-Channel Zigbee Relais DIN-Rail Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small bracket to mount the Aqara T2 to a DIN-Rail
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 59
- Makes
- 0
- Views
- 251
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a bracket to mount my Aqara T2 2-Channel Relais module on the Trident, so I made one. Put 2 heatsets into the body, screw the clip to the mount and you are good to go. Contains a small piece of inbuilt support, you can just push it out with a screwdriver after printing and then route the antenna through there.
BOM:
2x M3x4 standard Voron heatset inserts
2x M3x8 SHCS or BHCS screws
Print with standard Voron settings and shrinkage compensation turned OFF. This will fit just snug when printed in ABS/ASA. For PLA or PETG you might have to reduce the model size by ~0.5% or just glue the relais into the mount.
---
Also contains a remixed version of the DIN Rail Bracket Redux by @herr_brain, licensed under BSD-2
https://www.printables.com/model/472505-din-rail-bracket-redux