1 / 1
Bosch E Bike charger BCS220 holder (to be used with YAS) — zdjęcie 1

Bosch E Bike charger BCS220 holder (to be used with YAS)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a holder for the Bosch E-Bike standard charger BCS220 (4A). To be used with "Yet Another Shelf" (YAS).

Ocena
0 / 5
Polubienia
2
Pobrania
14
Wydruki
0
Wyświetlenia
621
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Introduction

This is a holder / bracket for the Bosch E-Bike standard charger BCS220 (4A). To be used with "Yet Another Shelf" (YAS).

 

What you need

  • Time: Printing time is > 7h
  • 4x socket head screws 3x12 mm
  • 4 washer M3 (outer diameter 7mm)

 

Printing

Print the holder, remove the support. Add the holder to the YAS.

 

Room for improvement

The holder was created using a lot of try and error using OpenSCAD. 

The slicing has been done so that the holder prints upright to avoid visible print enforcement on the top. However, this comes with a very long print time and alot of wasted filament.

 

Disclaimer

Neither mechanical nor thermal tests have been done. It is unknown how much load the holder can take. This “thing” has been published so that it can be used and re-mixed by anyone. Especially no experience has been gathered how the thing behaves if the charger gets hot. Use at your own risk. 

 

Tagi