Minimalist iPad Stand (Holds 1 or 2 iPads)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I designed this minimalist vertical stand to keep your iPad (or iPads) organized and save valuable desk space.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 79
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is specifically optimized to fit an 11-inch iPad (Pro or Air) while it is in a standard case. The slot is wide enough for most common slim cases (like the Apple Smart Folio).
It might also work for the larger 13-inch iPad, but I have not tested this. If you print it for a 13-inch model, please leave a comment to let others know!
This project includes two models:
-Single-Slot Version (Holds 1 iPad)
-Dual-Slot Version (Holds 2 iPads)
Cable Management
-Both versions include integrated pass-through holes for charging cables.
Important Cable Note: The charging holes are precisely modeled to fit the official Apple USB-C cable connector. Other third-party cables might be a tight fit or may require minor tinkering to fit, I used 3 sec glue to hold the cables in place
Printing Recommendations
-Supports are required.
-You will need to add supports (e.g., "Supports on Build Plate Only") for the cable pass-through holes to print correctly.
-Infill: 15-20% is recommended for good stability.
-Fuzzy Skin (Optional): To get the textured look from the photos, enable the "Fuzzy Skin" setting in your slicer (available in Cura, PrusaSlicer, etc.). I used the default settings for it.
If you have any issues or suggestions, please leave a comment below and I will try to fix it.
Hope you find this useful. Happy printing!