Skadis T-Nut Stalco AU915A charger mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Skadis T-Nut mount for Stalco charger AU915A
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Made from scratch, but inspired by this Makita charger mount. For mounting to Skadis board the M2.5 T-Nuts are needed and at least M2.5x12 counterbore screws. If you need different screws you can tweak the screw_* parameters in f3d file.
For ease of printing and clearance adaptation the mount uses 4 pegs printed separately. The pegs are very tight I used 0.2mm clearance for them, if yours doesn't fit you can change the peg_clearance for wider peg diameter and peg_smaller_diameter parameters in f3d file or adapt X-Y compensation (orca slicer) in your slicer.
Print settings
Printed the mount in PETG with the following print settings:
- 0.6 nozzle, 0.3 layer height
- 2 outer walls, 3 top/bottom shell layers
- 20% gyroid infill
- mount print orientation: laying on the front (the side without T-Nut guides) (use auto-orient)
- pegs print orientation: vertical, laying on the bigger diameter part (use auto-orient)
- no supports
