4 inch Enclosure Duct Fan (5015)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
4in duct vent fan for a 5015. Works with 4 inch dryer vent.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 780
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a duct mount for a 5015 fan to vent. It mounts inside a 4 inch dryer duct. Designed for use with a Creality enclosure, but will work for any 4 inch duct. The purpose is to vent toxic ABS fumes from the enclosure to the outside.
On the Creality enclosure, a 24V 5015 fan was used, powered by the 24V power supply from the printer.
It was printed with a .8mm nozzle with a .4mm layer height, but can be printed with a smaller nozzle and layer height. Since the enclosure will get warm during printing, we printed it in ABS. PLA may warp if the temperature inside the enclosure is too high.
No supports necessary, and the fan press fits into the model, and stays in place. If you have trouble, or require a more confident fit, a hole for a M4 nut and bolt (24-26mm long) can be used, with holes for the tool on the exterior shell. A zip tie around the vent can hold everything together.