Electric Chute Control Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple up, down, left & right control box for snowblower's electric chute controls that mounts to my Kioti's 2x2 ROPS.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 68
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a control box for my tractor's PTO snowblower electric chute controls. I printed this control box and ROPS mount with black PETG. I used 4 walls, 50% infill (gyroid), and no supports needed. It holds two momentary illuminated rocker switches. I used stainless #6 sheet metal screws that cut coarse threads into the box mounts pilot holes. The bracket clamps to the 2x2 ROPS using 6mm stainless hardware. Note: This box is not waterproof. My feeling was water will get in and always finds away in. The box fits loosely on the bottom/bracket, this loose fit coupled with the wiring holes in the bottom will allow the water to drain out.