Plunger Tube for Nessie/SLAB Blaster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Printable Model of the exact size of the plunger tube required for Nessie / SLAB foam dart blasters.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 273
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A 3D printable model of the plunger tube required for the Nessie blaster, which (as per the BOM) uses the same polycarbonate tube as the SLAB (Silly's Lever Action Blaster).
I designed this as per the SLAB's BOM as imperial dimensioned polycarbonate tubes are hard to come by here in the UK, and I didn't want to pay for the shipping to buy one from the USA where almost all the typical hardware kits come from.
I printed mine in clear resin which of course will be smoother and stronger than a typical FDM print of this wall thickness. It has worked very well for me. It was printed standing straight up on supports, and I used a high grit sandpaper to smooth out the end that was on the supports.
I did not sand the inside surface, but again you could wet sand it to get an even smoother finish - for me, it was not necessary. I did however lubricate the plunger during assembly.
4 inch Length, 1-1/2" Outer Diameter, 1-3/8" Inner Diameter
Nessie: https://www.printables.com/model/1409567-nessie-lowoptional-hardware-silly-shell-blaster
SLAB: https://www.printables.com/model/822836-slab-sillys-lever-action-blaster-nerf-homemade#hardware-kits
Disclaimer: This tube is not officially approved or recommended by the original creators of the Nessie or the SLAB, use at your own discretion.