Plunger Tube for Nessie/SLAB Blaster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D Printable Model of the exact size of the plunger tube required for Nessie / SLAB foam dart blasters.
- Rating
- 0 / 5
- Likes
- 17
- Downloads
- 42
- Makes
- 0
- Views
- 274
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A 3D printable model of the plunger tube required for the Nessie blaster, which (as per the BOM) uses the same polycarbonate tube as the SLAB (Silly's Lever Action Blaster).
I designed this as per the SLAB's BOM as imperial dimensioned polycarbonate tubes are hard to come by here in the UK, and I didn't want to pay for the shipping to buy one from the USA where almost all the typical hardware kits come from.
I printed mine in clear resin which of course will be smoother and stronger than a typical FDM print of this wall thickness. It has worked very well for me. It was printed standing straight up on supports, and I used a high grit sandpaper to smooth out the end that was on the supports.
I did not sand the inside surface, but again you could wet sand it to get an even smoother finish - for me, it was not necessary. I did however lubricate the plunger during assembly.
4 inch Length, 1-1/2" Outer Diameter, 1-3/8" Inner Diameter
Nessie: https://www.printables.com/model/1409567-nessie-lowoptional-hardware-silly-shell-blaster
SLAB: https://www.printables.com/model/822836-slab-sillys-lever-action-blaster-nerf-homemade#hardware-kits
Disclaimer: This tube is not officially approved or recommended by the original creators of the Nessie or the SLAB, use at your own discretion.