Clamping camera mounts for Philips Avent Connected

Clamping camera mounts for Philips Avent Connected.

DESIGN

Single piece.

Clamps on edges of about 2~2,5 cm (1 inch) thick. Fits well on a lot of IKEA furniture with ‘wooden’ side panels. Snaps perfectly on the small sides of the IKEA MYLLRA.

Small version sits at 45 degrees on the edge.

Long version is about 20cm (8 inches) long and as such raises the camera quite a bit about the edge it is clamped to. Sits at a steeper angle which, together with the raised height, allows for a better overview through the camera.

USAGE

Each mount has two pins that match the holes in the Avent camera. Do note there are varying version of these camera's. This one specifically works for camera's that have holes of about 3,9cm apart (1.5 inches) center-to-center.

PRINTING SUGGESTIONS

I've printed it with 2 perimeters and 4 perimeters at heights with the pins for some extra strength on these pins. Want to copy this settings? Look at or use the shared PrusaSlicer 3mf file. Otherwise you can choose to either print the entire model with 2 perimeters keeping it light and quick to print or printing the entire model with more than 2 perimeters for added strength of the pins but also increasing weight, print time, and cost.

The ‘pins’ require support. Nothing else required supports. Use organic supports and they will be quick to print and easy to remove. Look at the images attached (or use the supplied 3mf file) for best practice.

Any rigid material will work. In the pictures it is printed in Prusament Galaxy PLA.