90 Degree Hygrometer Mount for Comgrow Sovol SH02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is for those that have a Comgrow dryer box positioned 90 degrees to their printer to be able to read the hygrometer
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 275
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I only use my Comgrow for one dedicated filament at a time. It is on a riser in the back of my setup and I needed a 90 degree angle mount to see the readings so I created this. I tried several threaded designs but ended up just going back to a peg and hole design. It should work with two spools and be readable, but it does take up two holes on the Comgrow box. I use this https://makerworld.com/en/models/170624-spool-drying-box-sunlu-filament-dryer-s1-s2-s4#profileId-187293 ¾ spool dessicant holder in one slot. I get about 5-7% humidity according to Comgrow's measure as long as the mounted hygrometer stays at 10% I don't run the dryer.
Shopping List:
Comgrow Dryer
https://amzn.to/3XTSgTO
I used these hygrometers. Notice the mounts are at 6 and 12 O'clock in this design.
https://amzn.to/4pD2Gmw
I use this Alumina desiccant:
https://amzn.to/4rEq3Ou
I used Polymaker High Temp GF filament since the temperatures will reach 50 degrees:
https://amzn.to/4olWJsW
Depending on which filament you use, I added a peg selection to print. The hole is 5.15 MM on the mount. There is a 5mm-5.25mm peg selection in one stl. I printed in Bambu ABS black and ended up needing the 5.20 peg for a perfect fit.