90 Degree Hygrometer Mount for Comgrow Sovol SH02
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is for those that have a Comgrow dryer box positioned 90 degrees to their printer to be able to read the hygrometer
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 279
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I only use my Comgrow for one dedicated filament at a time. It is on a riser in the back of my setup and I needed a 90 degree angle mount to see the readings so I created this. I tried several threaded designs but ended up just going back to a peg and hole design. It should work with two spools and be readable, but it does take up two holes on the Comgrow box. I use this https://makerworld.com/en/models/170624-spool-drying-box-sunlu-filament-dryer-s1-s2-s4#profileId-187293 ¾ spool dessicant holder in one slot. I get about 5-7% humidity according to Comgrow's measure as long as the mounted hygrometer stays at 10% I don't run the dryer.
Shopping List:
Comgrow Dryer
https://amzn.to/3XTSgTO
I used these hygrometers. Notice the mounts are at 6 and 12 O'clock in this design.
https://amzn.to/4pD2Gmw
I use this Alumina desiccant:
https://amzn.to/4rEq3Ou
I used Polymaker High Temp GF filament since the temperatures will reach 50 degrees:
https://amzn.to/4olWJsW
Depending on which filament you use, I added a peg selection to print. The hole is 5.15 MM on the mount. There is a 5mm-5.25mm peg selection in one stl. I printed in Bambu ABS black and ended up needing the 5.20 peg for a perfect fit.