1 / 2
Condensate Drip Edge for Truma WK 24 Wall Chimney — zdjęcie 1
1 / 2

Condensate Drip Edge for Truma WK 24 Wall Chimney

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Drip edge for the Truma WK 24 wall chimney - keeps heater condensate off your caravan wall and prevents streaks.

Ocena
0 / 5
Polubienia
2
Pobrania
63
Wydruki
0
Wyświetlenia
173
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

When your gas heater is running, water condenses on the Truma wall chimney and runs down the outside of the caravan or camper. Over time this leaves dirty streaks and water marks below the chimney.

This drip edge fits onto the Truma WK 24 wall chimney. It collects the condensate and lets it drip off at a defined point, clear of the wall, so it no longer runs down the side of your camper.

Features

  • Fits the Truma WK 24 wall chimney with 78 mm diameter

  • Keeps condensate off the outside wall and prevents streaks

  • [Mounting: e.g. clips on / is bonded with … / uses the existing screws] – no drilling required [only if that’s true]

  • Prints without supports [adjust if needed]

Print settings (recommended)

  • Material: PETG or ASA (UV- and weather-resistant). PLA is not recommended because it deforms in sunlight and near the warm chimney

  • Layer height: [0.2 mm]

  • Walls: [3–4]

  • Infill: [20–30 %]

  • Supports: [none]

  • Orientation: [as provided in the file]

Installation

  1. Clean the chimney cover and let it dry

  2. Take off the two screws and remove the outer shield, put the part in place and re-tighten the shield

  3. Check that the exhaust openings stay completely clear

Important
Do not block or narrow the exhaust or air intake openings of the wall chimney. Only use heat-resistant material and check the part regularly. Installation and use are at your own risk. This is an unofficial accessory and is not affiliated with or endorsed by Truma.

Tagi