Condensate Drip Edge for Truma WK 24 Wall Chimney
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drip edge for the Truma WK 24 wall chimney - keeps heater condensate off your caravan wall and prevents streaks.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 63
- Makes
- 0
- Views
- 173
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
When your gas heater is running, water condenses on the Truma wall chimney and runs down the outside of the caravan or camper. Over time this leaves dirty streaks and water marks below the chimney.
This drip edge fits onto the Truma WK 24 wall chimney. It collects the condensate and lets it drip off at a defined point, clear of the wall, so it no longer runs down the side of your camper.
Features
Fits the Truma WK 24 wall chimney with 78 mm diameter
Keeps condensate off the outside wall and prevents streaks
[Mounting: e.g. clips on / is bonded with … / uses the existing screws] – no drilling required [only if that’s true]
Prints without supports [adjust if needed]
Print settings (recommended)
Material: PETG or ASA (UV- and weather-resistant). PLA is not recommended because it deforms in sunlight and near the warm chimney
Layer height: [0.2 mm]
Walls: [3–4]
Infill: [20–30 %]
Supports: [none]
Orientation: [as provided in the file]
Installation
Clean the chimney cover and let it dry
Take off the two screws and remove the outer shield, put the part in place and re-tighten the shield
Check that the exhaust openings stay completely clear
Important
Do not block or narrow the exhaust or air intake openings of the wall chimney. Only use heat-resistant material and check the part regularly. Installation and use are at your own risk. This is an unofficial accessory and is not affiliated with or endorsed by Truma.