1 / 7
SpeedyBee Maser 5 v2 - Mateksys M10Q-5883 GPS Compass Mount Rear (20x20 mm) — zdjęcie 1
1 / 7

SpeedyBee Maser 5 v2 - Mateksys M10Q-5883 GPS Compass Mount Rear (20x20 mm)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A mount for the Mateksys M10Q-5883 GPS & Compass module fitting the Speedybee Master 5 v2 RC drone.

Ocena
0 / 5
Polubienia
2
Pobrania
46
Wydruki
0
Wyświetlenia
255
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Purpose

This mount allows the Mateksys M10Q-5883 GPS & Compass module to be fastened to the Speedybee Master 5 v2 RC drone. It mounts the module to the drone's rear. Special care was taken to design the mount such that the module sits level with ground. This makes the compass setup, for example in Ardupilot, Inav, or Betaflight, more straight foreward.

Hardware

  • TPU
    or similar FLEX

For printing the mount.

  • PLA

For printing the support structure [red geometry in images].

  • Original screws

For fastening the mount to the drone.

Tips & Comments

  • The support blocks are printed in PLA (does not stick to TPU) and get manually placed under/into the TPU print. Simply set a manual pause command prior to the first respective briding layer, insert the support block, and resume the TPU print. The arrow on the upper support block indicates the mount's front. Otherwise, it is difficult to tell the parts correct orientation by bare eyes.

  • Shield the GPS/compass module's cable going to the flight controller with aluminum foil or aluminum tape. This will block the majority of the HF interference. Make sure to wrap the shielded cable into non-conductive tape (e.g. kapton). This will add abrasion resistance and makes sure no other components get shorted out.

Note:

  • The gcode includes two color change commands as the pause commands. While unloading and reloading the same flex filament is required, it ensures that the nozzle is primed before resuming the print.

  • The gcode information in the header utilizes PrusaSlicer's "balanced" print profiles.

Tagi