Everything Remote - Higher Clearance for Top Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Added 0.5mm to the inset seam so it would interface with the bottom shell preventing accidental presses.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 250
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed on a Bambu P1S with Bambu Basic PLA.
Also had these issue on Ender 3 and Sovol SV01 with multiple different filaments. So I think the Z-height just needs to be adjusted.
This is not a uniform scale of the entire model. Its ONLY the perimeter and the latches.
These changes prevents the case from bending when the buttons are inserted and trying for final assembly. The PCB sits flat when inside the bottom shell. So testing showed that the button height was causing the brightness buttons, power button, or play/home/back buttons to be pressed as the middle was bowing.
I think in the current design I also reduced the button Z height from 3.95 to 3.35mm. Now there's a bit more wiggle, but now I can increase that to find the sweet spot. I didnt have to adjust the select (centre) button as that is taller but is recessed inside the d-pad.