mStand-inspired Phone Stand - remix for stability and function
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adjusted original for stability and function - holds your phone and routes your cable.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 78
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Made some quality of life changes to this to better align it to my use case, you might find it useful. I liked the original but there were a couple things I wanted to change. Images attached here show my version in metallic brown, the original version in black.
Adjusted height for better cable clearance. Lengthened base, adjusted tilt angle from rear to tilt it forward 5 degrees and adjusted front tilt to maintain original presentation angle, and reduced rear curve radius for stability and to reduce front-back tippiness. Adjusted cable route hole - smaller in horizontal direction, larger in vertical direction to fit a broader variety of cables. Adjusted holder part to be parallel to base of phone when placed on stand for better interface. Increased depth here to fit a broader variety of phones/cases.
Print instructions - I used the following which slightly varies from the original as well, and the pictures here show it printed in PLA.
.2mm layer height, 5 wall loops, 25% gyroid infill, supports enabled (.24mm top z offset). Lay on its side for printing.