Jonsbo C6 Handles/Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple model that replaces the corner braces with a handle, I recommend using a handle on both sides.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 332
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This model serves to allow an easy way to add a handle or feet to the Jonsbo C6 computer case. I purchased one C6 with the stock strap and it was alright but then I needed a second white one and I could not find one with the strap. So I figure let me go ahead and make a nice handle for the case. This can also be used on the bottom as feet to raise it up. Recommended print parameters are PETG, with 5 perimeters and at minimum 25% gyroid infill. The stock screws can be used on the left and right sides but there is a recessed area for a longer M3x25 screw, this is what gives it the most strength so I would not forgo it.