Jonsbo C6 Handles/Feet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple model that replaces the corner braces with a handle, I recommend using a handle on both sides.
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 36
- Makes
- 0
- Views
- 337
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
This model serves to allow an easy way to add a handle or feet to the Jonsbo C6 computer case. I purchased one C6 with the stock strap and it was alright but then I needed a second white one and I could not find one with the strap. So I figure let me go ahead and make a nice handle for the case. This can also be used on the bottom as feet to raise it up. Recommended print parameters are PETG, with 5 perimeters and at minimum 25% gyroid infill. The stock screws can be used on the left and right sides but there is a recessed area for a longer M3x25 screw, this is what gives it the most strength so I would not forgo it.