Terrier Shroud w/ Picatinny for X-Shot MPP
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Terrier Handguard with bottom Picatinny rails.
- Ocena
- 5 / 5
- Polubienia
- 39
- Pobrania
- 180
- Wydruki
- 2
- Wyświetlenia
- 938
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the Terrier Handguard from LoneWolf052 and the bottom Picatinny rail from the Utonagan Handguard Remix from HoneyBajjar.
I wanted to have Picatinny instead of Mlok for the bottom rail of the Terrier since I liked the design, but didn't have many attachments that used Mlok.
When I printed mine, I messed up the angle on the bottom Picatinny and the shell partially, but I have corrected both of the problems with the new included files. Also with my version I bought the wrong type of screw, I bought a button head instead of a socket head, so I had to dremel down the holes to make it fit, please don't make the same mistake as me, and just buy standard socket head screws instead. (See hardware below). I ended up spray painting mine and I believe that this shroud makes this blaster look complete (see last image).
This version works exactly the same as the original Terrier, and takes the same hardware.
Hardware:
This uses the same hardware needed as the original Terrier:
2x M5x30mm screw (make sure it is not a button head or a larger size than a standard socket one)
2x M5 hex nuts
- Warning -
Please do not print the STL, print the 3MF instead, as it has the correct supports and orientation.
Printing Stats:
Printed on BambuLab P1S
Printed w/ specific supports (only necessary on lower Picatinny)
Printed at the same angle as the original Terrier
Printed w/ 10% infill
Printed w/ 0.2mm layer
I have included both the STL and 3MF files for ease of printing.
Thanks again to LoneWolf052 and HoneyBajjar.