Arasaka Dice Tower - no supports, no glue

Remix of a model published here on Printables by user @Sable , from the original publication:

Dice tower based off of Cyberpunk 2077 and Edgerunners' Arasaka Tower

Prints in three parts, required print dimensions 200x200x250mm 

Contribution by Dany Sánchez of MiniWorld3D:

• Added angle chamfers to eliminate the need for supports.
  The only overhang is at the opening where the dice come out of onto the tray, which is a long bridge but perfectly printable without supports by modern printers with good cooling and speed.
   
• Added pegs, so that parts fit with each other, eliminating the need for glue.
  You can still use glue for a more secure and permanent fix, the pegs allow for perfect alignment of parts.  Depending on the filament, the printer and your settings, the fit may be a bit loose or a bit tight, due to the nature of tolerances. Sanding or shaving with a knife may be needed for a good fit. 
   
• Added 3MF for ElegooSlicer that includes optimized settings 
  See slicer screenshots further below.
   

Print credits: by Johnny Bland on an Elegoo Centauri Carbon, Prusament Galaxy Black PLA, and the settings shown below.

Print settings -------

• No supports
   
• No brims
   
• Recommended 0.28 mm layer height, 15% lightning infill, seam position “back” 
   
• The logo can still be printed separately and pause-to-change filament color  in order to have a black background and a white logo.