LUMONITE Vector Headlamp Mount for Peltor WS Alert XPV

This is a custom mount designed to attach a LUMONITE Vector headlamp to the top band of PELTOR WS Alert XPV hearing protectors.
It allows you to place the lamp on top of the headset without using the original headband or helmet adapter. 

The top surface uses a honeycomb pattern  to minimize shadowing on the WS Alert XPV’s solar panel while maintaining strength and stiffness.

The clip follows the curvature of the PELTOR headband and snaps into place without screws or tools.
It has been tested on the WS Alert XPV, and the band dimensions are similar across many PELTOR models, so it may also fit other variants with a comparable top-band width. 

The attachment method is compatible with many LUMONITE headlamps that use the same mounting interface as the Vector.
Fit may vary depending on model.

An alternative version with a slight sideways tilt is also included.
The angled mount raises the light beam above head height , preventing the lamp from pointing too low and improving forward visibility.

Features

• Designed for LUMONITE Vector
• Tested on PELTOR WS Alert XPV
• May fit other PELTOR models with similar band dimensions
• Snap-fit design (no tools needed) 
• Supports many LUMONITE lamps using the same connector
• Fits lamp bodies approx. 20 mm in diameter 🔍
• Honeycomb top reduces shading on the XPV solar panel 
• Sideways-tilt version lifts the beam for better visibility 

Print Settings

• Material: PETG or ABS recommended
• Layer height: 0.2 mm
• Infill: 15–20%
• Perimeters: 3
• Supports: Only on build plate

Notes

PETG/ABS performs better outdoors and in cold conditions compared to PLA.